ul dimmable 8 inch ROUND SUPER THIN RECESSED LED LIGHTING FIXTURE 18W
1/2″ Thick LED fixture that fits directly under joists. Maximum layout flexibility.
THE ULTIMATE HOME RENOVATION ECONOMY – BUILDER GRADE LED LIGHTING FIXTURE. INSTALLS FAST & EASY
For Insulated & Dropped Ceilings and Soffits.
- cULus Listed and Energy Star Certified
- Type IC Rated – Approved for Direct Contact with Insulation
- Air-Tight, Damp Location, Insulated and Non Insulated Ceilings
- Pot Light Housing is NOT Required even for Insulated Ceilings
- Warranty: 5 Year
- Rated Life: 36 000 Hours
- model: DA-RL8W18
Round 8″ fixtures with integral LEDs. Class 2 isolated external driver factory installed inside junction box.
One driver for every fixture required.
Cut out hole in ceiling (7 3/4″ to 8 1/2″) and snap fixture in opening with attached spring clips.
Space in ceiling needed for the driver to fit through the hole – 1 1/2″.
- Driver Input Voltage: 120V AC (Dimmable)
- Power factor: > 0.98
- Energy Used: 18W
- Halogen equivalent: 120W
- Beam Angle: 110°
- Light colour options: Warm White 3000K and Neutral White 4100K
- Light output: Warm White 1200 lm, Neutral White 1260 lm
- CRI: 82 for the 3000K and 82 for the 4100K
- Ambient Operating Temperature: -40°F (-40°C) to +104°F (+40°C)
- Compliance: cULus Listed, certified to CSA STD. C22.2 No. 250.0
- Rated: Type IC (Direct Contact with Insulation), Energy Star, Air-Tight
- ID 7 1/2″; OD 9″; Thickness 1/2″
- Cut out: 7 1/2″ to 8″
- Junction Box Dimensions (with driver inside): 3 3/4″ x 3 3/8″ x 1 1/2″
Suitable for damp locations and soffit installations.
- ALL FIXTURES MUST BE INSTALLED IN ACCORDANCE WITH CURRENT APPLICABLE ELECTRICAL CODES.
CONNECTING THE DRIVER:
Open the cover of the junction box. Push and remove one of the half-inch knockouts on the side plate. Install standard L16 cable connector. Use double connector for daisy chaining multiple drivers. Insert line voltage feed into the cable connector and splice same colour wires using wire nuts. Close the cover. Connect the driver to the light fixture – the arrows on the male and female parts of the connector between the driver and the fixture should match. Tighten the connector by hand. Do not attach the junction box to anything so you can pull it through the ceiling opening in case you need to service the driver in future.
OPTIONS FOR LOCATING DRIVER:
Fixture comes connected to the driver by 12″ long low voltage cable with waterproof connector in the middle.
Depending on where you want the driver to be you have 2 options:
- Locate next to the fixture – run line voltage wiring to first junction box and “daisy chain” to the junction boxes of the other fixtures.
- Or install all drivers at one location and use low voltage extension cables to the fixtures. Use only extensions provided by the manufacturer. Available jumper cables are 10 feet (3m) – cat # EXC10. Cables are linkable.
Maximum run should not exceed 40 feet (12m).
We recommend LED/CFL dimmers that have a low range adjustment dial. After all fixtures are connected to the dimmer adjust the dial to the lowest position before the lights start to flicker of shut down. This setting depends on the local voltage and number of fixtures per dimmer
LIST OF COMPATIBLE DIMMERS
DO NOT USE ANY OTHER DRIVERS EXCEPT THE DANS DRIVERS THAT ARE INCLUDED WITH THE FIXTURE.
DO NOT CONNECT MULTIPLE FIXTURES TO ONE DRIVER.
DO NOT OPEN THE LIGHT FIXTURE AND THE SIDE PLATES OF THE DRIVER – NO SERVICEABLE PARTS INSIDE.
- LIGHT COLOR
- Warm White 3000K is yellowish, similar to halogen and incandescent light. Creates soft, calming feeling. We recommend the Warm White for bedrooms, living rooms and kitchens with warm coloured countertops and cabinets.
- Neutral White 4100K is whiter, colder and more energizing light. Using this colour will make the room look white, modern and brighter. We recommend the Neutral White for bathrooms, offices and work areas, garages, kitchens with white or dark countertops and cabinets.
Our experience with LED recessed lighting fixtures since 2008 shows that about 70% of our customers prefer the Warm White and 30% like the Neutral White.
1. Reply your inquiry in 24 working hours.
2. Customized design is available, OEM and ODM are welcomed.
3. Delivery the goods to our customer all over the world with precision speed.
4. Offer customer the lowest price with high quality products.
5. Please feel free to contact me if you have any related questions.
my company has opened Alibaba credit assurance service.